Microcom 814M Návod k obsluze stáhnout pdf (Strana 35)

5.2.4 Paper Retract Sensor

The paper retract sensor should be cleaned whenever the following circumstances occur:

• Paper fails to retract and printer does not signal retract failure.

• Paper retracts, but printer signals retract failure.

To clean the paper end sensor, follow the steps below:

• Turn off the power and turn the printer over.

• Locate the paper retract sensor (see figure 5-2).

• Wipe off dust and stains on the surface of the paper loading sensor with a cotton swab dampened with

isopropyl alcohol.

• Allow isopropyl alcohol to evaporate.

Figure 5-1 Paper Out Sensor

Figure 5-2 Presenter Paper Retract Sensor

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 45 46

Žádné komentáře

Microcom 814M Návod k obsluze Strana 35