Microcom 48-466 Návod k obsluze Strana 42

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 88
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 41
Printer Commands Chapter 5
48-466 Operators Manual36
^A ^D COMMAND
23 Change SW3: Software dip switch #3. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.
Detect Black Line On Power-up
******.Q
Always 0
*****.)Q
Always 0
****.))Q
Always 0
***.)))Q
Always 0
**.))))Q
1=Send Response After Print
**
0=No Response After Print
*.)))))Q
Always 0
.))))))Q
1=Disable Extended ASCII, 0=Enable
Position:
1 Extended ASCII: If enabled, characters over 7F hex will be processed.
2 Always 0
3 Response After Print: If enabled, an enquiry response will be sent back through the
serial port after every print.
4 Always 0
5 Always 0
6 Always 0
7 Always 0
8 Detect Black Line on Power-up: If this bit is set, the printer will automatically run
a few labels and correctly set the ^D91 value.
Zobrazit stránku 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 87 88

Komentáře k této Příručce

Žádné komentáře