Microcom 428TM Návod k obsluze stáhnout pdf (Strana 147)

Chapter 7 Downloadable Fonts

428TM Operator’s Manual - 880042-0141 7-7

^A ^D COMMAND

100 Clear User RAM:

This command clears all downloadable fonts, graphics, and stored label

formats.

101 List Memory Bytes Available:

The printer will send the “>” character followed by the amount of available

bytes and then finally a “<” character. (i.e. >192690<)

XX 104 Load GRAPHIC or FONT into RAM Memory without Compression:

The ^Axx specifies which memory slot to place the image/font (1-255). This

command should be used with an ASCII-HEX file that contains only printable

characters less than 80 HEX. This command supports GRAPHICS over

64KB.

XX 106 Load GRAPHIC or FONT into RAM Memory without Compression:

This command is intended for legacy support only and Microcom Corporation

recommends either the ^D104 or ^D107 commands. Fonts must be less than

64KB for this command to function.

XX 127 Save FONTS to RAM.

(See Section 7.4.1.1)

XX 135 Save a FONT to FLASH.

(See Section 7.4.1.2)

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 242 243

Žádné komentáře

Microcom 428TM Návod k obsluze Strana 147