Microcom LDSII Uživatelský manuál stáhnout pdf (Strana 58)

Printer Commands Chapter 2

42 LDSII Programming Guide - 880015-0123

Printer Model

Number

Recommended

^D648 Value

226 2.32”

326M 1.36”

426M 1.36”

426 2.32”

Table 8 Blackline Sensor to Print Head Distance

2.5.19 ^D649)n (Set Gap Sensor to Print Head Distance)

The “^D649)” command is used to set the gap sensor to print head distance at the factory.

This command is a “property” which means that it controls a specific distance that is set at

the factory. The property commands may be set back to their default values using the

“^D392)1” command.

Printer Model

Number

Recommended

^D649 Value

226 2.34”

326M 1.38”

426M 1.38”

426 2.34”

Table 9 Gap Sensor to Print Head Distance

2.5.20 ^D655)n (Set Labels Printed)

This command gives the user the ability to set and/or reset the “Labels Printed” counter of

the printer that is reported either by issuing the “^D655)” without a parameter or “^D324)”

(List Statistics) command.

2.5.21 ^D670) (Set Serial Port)

The “^D670)” command is used to configure the serial port. The command starts with the

“^D670)” and is then followed by four parameters or arguments. The first parameter must

be separated from the ^D command by a space and the following parameters must be

separated from each other using the comma delimiter. The command is entered using

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 120 121

Žádné komentáře

Microcom LDSII Uživatelský manuál Strana 58